Menu
My last option would be to 'remove the cmos battery' for a few minutes. This is the first Sony Laptop that I take apart. And all I can say is.
Introduction
Use this guide to replace your PlayStation 3's proprietary PRAM battery.
- Phillips #1 Screwdriver
- Spudger
- T10 Torx Screwdriver
- Sony PlayStation 3 Models A, B, C, and E PRAM Battery$9.99
- Use the tip of a spudger to remove the black rubber screw cover from the side of the PS3.
- The screw cover may be underneath a warranty sticker. This sticker will change appearance, and show 'VOID' after it has been removed.
- Remove the single 8.5 mm T10 Security Torx screw from the smart plate.
- Pull the smart plate toward the hard drive bay, then lift it off the body of the PS3.
- Be sure to keep track of the small metal bracket loosely held in the top cover, if equipped.
- Remove the following seven screws:
- Six 52 mm Phillips screws
- One 30 mm Phillips screw
- Lift the top cover from its rear edge and rotate it toward the front of the PS3.
- Remove the top cover.
- There is a plastic hook located in a hole on the top back right hand side corner. Carefully push the plastic hook a bit front the rear of the machine with a spudger to release the rear right of the casing.
- Disconnect the Blu-ray power cable from the motherboard.
- Pull the connector straight up and out of its socket.
- Lift the Blu-ray drive from the edge nearest the power supply and rotate it away from the chassis enough to access its ribbon cable.
- Use your fingernail to flip up the retaining flap on the Blu-ray ribbon cable socket.
- Be sure you are prying up on the retaining flap, not the socket itself.
- Pull the ribbon cable out of its socket.
- Remove the Blu-ray drive from the PS3.
- If replacing the Blu-ray drive, transfer the power cable to your new drive.
- Pull the control board ribbon cable straight up and out of its socket on the motherboard.
- Remove the two 12 mm Phillips screws securing the control board to the lower case.
- Remove the control board and its attached cable from the PS3.
- Remove the following eight screws securing the motherboard assembly to the lower case:
- Seven 12 mm Phillips screws (ph2)
- One 30 mm Phillips screw
- Remove the control board bracket.
- Use the flat end of a spudger to pry the hard drive bay cover away from the lower case.
- Remove the hard drive bay cover.
- Lift the motherboard assembly out of the lower case.
- Disconnect the PRAM battery from the motherboard.
- Be careful when separating the connector from its socket, as the socket easily breaks of the motherboard. If possible, hold down the socket as you lift the connector.
- Rotate the PRAM battery counter-clockwise and remove it from the chassis.
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
10 other people completed this guide.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.